I inadvertently defaulted a Vista 20P panel with 30-some RF
transmitters, including one RF PIR and one RF smoke sensor. After
reprogramming I am confronted with the following problem: When I
violate a zone, that zone will show up on the keypad as open. When I
restore that zone, it still shows up as open. I violate a second,
third, etc zone, all those zones show up as open, but continue to show
open after closing the door or window. The only way to get rid of the
fault messages is to get in and out of installer programming. What am
I doing wrong?
The zones are programmed as contact ID. In *56 I am fairly certain as
to what to put in Zn, ZT, and P. I am a bit more shaky as to what to
put in RC, IN:, and L. For the latter three I put throughout RC = 10,
IN: = RF, and L = 1.
Any pointers would be much appreciated.
|
