Randybr had written this in response to
http://www.secure-gear.com/alt.security.alarms/5/Re-Defaulting-Napco-Gemini-P800-article5930-.htm
:
Sorry about the delay.. heh... but an 800 can be reset to factory defaults
by powering it down completely, shorting terminals 3 and 15, apply power
briefly,
then remove jumper and power up.
-------------------------------------
Stanley Barthfarkle wrote:
> Solution? New board? Send to Rojas? Thx.
> "Mark Leuck" <m..leuck@[EMAIL PROTECTED]
> wrote in message
> news:nMmdndi3ZqM4DaHeRVn-sg@[EMAIL PROTECTED]
>> Can't
>>
>> "Stanley Barthfarkle" <sbarth@[EMAIL PROTECTED]
> wrote in
>> message
>> news:390%e.1490$cF6.1394@[EMAIL PROTECTED]
>>> Hi all,
>>>
>>> How do I go about defaulting the dealer code on the Napco
>>> Gemini P800? I
>>> think it's locked out. Thanks.
>>>
>>>
>>
>>
##-----------------------------------------------##
Delivered via http://www.secure-gear.com
The Internet Knowledge Base for the security industry
no-spam access to your favorite newsgroup -
alt.security.alarms - 43800 messages and counting!
##-----------------------------------------------##
